Automatic equipment for the production of ready meals lasagna and cannelloni mod. CN/2000
The operations of sheet lamination, die-shaping, cooking in water and cooling are positioned in the inferior part. Filling, forming and cutting take place in the superior part.
The machine CN/2000 is completely built in stainless steel and it is thought for easy access to clean every part. The filling and the length of the cut are adjustable, while the cooking time of the sheet in water is about 2 minutes. The width of the sheet at the input is mm 280.
The forming system of the cannellone allows the same production as the manual one. The electrically fed machine has a consumption of 7 kW and does not need any suction system since it does not produce smokes of combustion. The same machine can produce pre-cooked sheets with adjustable width, thickness and length.
Dimensions bxpxh mm 650x1950x1950 h Weight kg 320 Hourly output N° 700 pezzi Sheet width mm 280 KW 7 Voltage 3F 230-400 50/60HZ
[video_lightbox_youtube video_id=pHVCtwh1rN4 width=640 height=480 anchor=http://pastaequipments.pj0nndtagahrsabj8qsiytnlep4ldfmdd.netdna-cdn.com/wp-content/uploads/2011/11/quicktime.gif]
Automatic equipment for the production of ready meals lasagna and cannelloni mod. CN/3000
The Extruder or Automatic Sheeter makes the dough and forms the pasta sheet, that falls then into a conveyor belt and is transported to the cooker. Inside the cooker water is heated through a heat generator at an optimal temperature (always less than 100 C.)
This generator is able to move inside the cooker. The belt speed can be varied, changing this way the cooking time.
There are two stainless steel belts one on top of the other, that connect with the cover once they are inmersed.
The cover-belts group can be lifted through an automatic device in order to facilitate cleaning. It is also possible to lift only the cover.
The introduction of two extractor hoods, one at the entrance and one at the exit of the pasta sheet , is without a doubt an important innovation.
This system allows not to take vapor from the bin but rather to keep the absolute quantities constantly during the whole productive cicle. The two cooking belts take the sheet towards the exit of the bin, and pass it through the washing and cooling bin. This last one contains water at room temperature.
An immersion cylinder allows to keep the sheet in the water. Then the longitudinal cutting device divides the sheet into two, three or four strips, separating and putting them on the belt where they are going to be shaped.When producing cannelloni the filling coming from the filler and doser group is dropped continously.The patented rolling group makes the filled pasta sheet into a cannellone. The cutting device cuts the cannelloni into the desired measure.
On the other hand when producing lasagna, the filler and doser group don’t activate, allowing for the production of lasagna sheets of variable measures if desired. This system permits to control the whole production process and the problems that might arise.
[video_lightbox_youtube video_id=F7k1MFANsKQ width=640 height=480 anchor=http://pastaequipments.pj0nndtagahrsabj8qsiytnlep4ldfmdd.netdna-cdn.com/wp-content/uploads/2011/11/quicktime.gif]